FROG @EASE FLOATING SYSTEM
START UP:
MAINTENANCE:
EASE FLOATING WRITTEN INSTRUCTIONS
-
The spa will heat, once filled, at about 3 degrees and hour, it make take a day or so for spa to fully heat. While it is heating you can start adding chemicals.
-
First you will need your @ease floating box (see photo on back)
-
Remove the SmartChlor Cartridge (in the bag, grey colored) and twist setting to #2 and attach it to the floating Mineral Cartridge (blue) by screwing the blue on top of the grey. Place the floater into the spa water.
-
Pour the packet of @ease Jump Start into the water (packet in the @ease box labeled “jump start”)
-
Use a Test Strip to measure pH, Alkalinity and Total Hardness levels and adjust as necessary: (all following chemicals will be in your starter box)
-
Add 10 to 16 ounces (1/3 to 1/2 bottle) of Calcium/Hardness Increaser (for most areas)
Note: Amount varies by location but typically is going to be approx. 1/2 to 1/3 of the bottle – add Calcium Booster until Total Hardness is between 150 – 250 ppmAdd 2 to 3 ounces (TBSP) pH Up/pH Increaser (for most areas)
Note: Amount varies by location – add pH Up or pH Down until the pH level is between 7.2 to 7.8 and the Alkalinity level is between 80 and 120 ppm
WEEKLY
MAINTENANCE
-
Add 2 ounces (TBSP) of Oxidizing Shock (or Renew/Replenish) and run jets with cover off for 15 minutes
-
Use Test Strips to check SmartChlor level, Total Alkalinity and pH levels and adjust as necessary
Note: If SmartChlor level is low or zero add Chlorinating Granules and check the SmartChlor cartridge. If the SmartChlor cartridge is empty, replace it with a new one. If it is not empty, increase the setting
of the SmartChlor cartridge to setting 3 or 4 to increase the chlorine level in the water
Note: If the pH is too low add 2 to 3 ounces (TBSP) of pH Up to raise pH and Alkalinity
MONTHLY MAINTENANCE
-
Add 2 ounces (TBSP) of Oxidizing Shock (or Renew/Replenish) and run jets with cover off for 15 minutes
-
Use Test Strips to check SmartChlor level, Total Alkalinity and pH levels and adjust as necessary
Note: If SmartChlor level is low or zero add Chlorinating Granules and check the SmartChlor cartridge. If the SmartChlor cartridge is empty, replace it with a new one. If it is not empty, increase the setting
of the SmartChlor cartridge to setting 3 or 4 to increase the chlorine level in the water
Note: If the pH is too low add 2 to 3 ounces (TBSP) of pH Up to raise pH and Alkalinity
OTHER MAINTENANCE
-
Drain and refill the spa water every 3 to 4 months (quarterly)
-
Replace @ease Mineral Cartridge every 4 months (replace whenever spa is drained and refilled with fresh water)
-
Use JET CLEAN/SPA PURGE/SPA500 every 12 months to clean out internal plumbing, jets and heating system
-
If water is cloudy and/or foamy: Add 1 ounce of Clarifier, add 2 TBSP of Shock/Replenish and clean filters